锂电池涂布烘箱风嘴射流压强分布优化研究-包装工程.pdf

包 装 工 程 第40 卷 第 5 期 ·180 · PACKAGING ENGINEERING 2019 年3 月 1,2 2 1 2 （1.哈尔滨工业大学（深圳） 机电工程与自动化学院，深圳 518055 ； 2.赢合科技股份有限公司，深圳 518000 ） 目的 烘箱射流风嘴对极片烘干的均匀性和一致性具有重要影响，拟改善干燥过程中由于射流压 强分布不均导致的极片烘干质量不良问题。方法 利用SolidWorks 软件对射流风嘴与极片间的空气流体 域进行建模，基于k-ε 湍流方程完成热风流场的数值仿真计算，根据流体仿真结果对射流风嘴结构进行 优化设计，最后通过实验对数值仿真计算结果进行验证与完善。结果 经数值仿真优化后的极片与风嘴 间压强分布较改进前有较大提升，在相同的测量位置处，仿真得到的压强差由20 Pa 下降到了8 Pa ，实 验得到的压强差由21 Pa 下降到11 Pa，在误差允许范围内，实验结果与仿真结果基本保持一致。结论 优 化后的射流风嘴完善了射流压强分布，数值仿真研究对风嘴结构的优化设计具有重要的指导意义。 涂布机；烘箱；流体仿真；风嘴；压强分布 TS803.6 A 1001-3563(2019)05-0180-07 DOI 10.19554/j.cnki.1001-3563.2019.05.025 Jet Pressure Distribution Optimization in Air Nozzle of Lithium Battery Coating Oven 1,2 2 1 2 CHENG Qian-ju , HE Si-qing , HU Hong , YUAN Deng-hang (1.School of Mechanical Engineering and Automation, Harbin Institute of Technology (Shenzhen), Shenzhen 518055, China; 2.Yinghe Technology Co., Ltd., Shenzhen 518000, China) ABSTRACT: The work aims to avoid the poor quality of the pole piece drying due to the uneven distribution of the jet pressure during the drying process, because the oven jet nozzle has an important influence on the uniformity and consis- tency of the lithium battery pole piece drying. The air fluid domain between the jet nozzle and the pole piece was mod- eled by the SolidWorks software and the numerical simulation of warm air fluid field was calculated by the k-ε turbulence equation. The design of the jet nozzle structure was optimized according to the fluid simul