原创力文档- 1
- 0
- 约8.95千字
- 约 16页
- 2019-07-20 发布于湖北
- 举报
XX石化炼油厂大修减粘反应器更换
目录
概述········································1
减粘反应器2的吊装受力计算··················6
减粘反应器3的吊装受力计算··················16
吊轴核算····································25
锚点的选用··································31
所需机具计划································32
机具汇总表··································35
吊装施工技术要求····························39
吊装施工安全技术措施························42
反应器2·3吊装立面图
平面布置图
吊耳施工图
XX石油化工总厂炼油厂减粘装置减粘反应器更换吊装方案
概述：
XX石油化工总厂炼油厂减粘装置，在92年度大检修期间，需更换反应器2，反应器3，由于装置布置紧凑，场地狭窄，设备高大，现根据现场实际情况，拟采用自制的800KN/25.5m门式抱杆进行设备整体拆除与安装。
1、设备规格：
减粘反应器2：
设备直径： Φ3200*24mm
设备总长： 23451mm
文档评论（0）