建筑工程专业英语（910）.ppt

Unit 9 Cladding System Part ⅠIllustrated Words and Concepts Figure 9-1 Stick System Figure 9-2 Unit System and Unit-and-Mullion System Figure 9-3 Panel System and Column Cover and Spandrel System Part Ⅱ Passages Passage A The Design Requirements for Cladding Passage B The Curtain Wall Unit 9 Cladding System Part Ⅰ Illustrated Words and Concepts Figure 9-1 Stick System 1-Anchors 2-Mullion 3-Horizontal rail( gutter section at window head) 4-Spandrel panel (may be installed from inside building) 5-Horizontal rail (window sill section) 6-Vision glass (installed from inside building) 7-Interior mullion trim Other variations: Mullion and rail sections may be longer or shorter than shown Vision glass may be set directly in recesses in framing members, may be set with applied stops, may be set in sub-frame, or may include operable sash. Unit 9 Cladding System Part Ⅰ Illustrated Words and Concepts Figure 9-2 Unit System and Unit-and-Mullion System (A) Unit System—Schematic of typical version 1-Anchor 2-Preassembled framed unit. Other variations: Mullion sections may be interlocking “spilt” type or may be channel shapes with applied inside and outside joint covers. Units may be unglazed or may be Pre-plazed .Spandrel panel may be either at top or bottom of unit. (B) Unit-and-Mullion System—Schematic of typical version 1-Anchors 2-Mullion(either one-or two-story lengths) 3-Preassembled unit-lowered into place behind mullion from floor above 4-Interior mullion trim. Other variations :Framed units may be full-story height (as shown)，either unglazed or pre-glazed, or may be separate spandrel cover units and vision glass units. Horizon