PUSHBUTTON FEA模块功能特点介绍.pptx

PUSHBUTTON FEA?;Problem: “Mesh” deformation;Problem: “Jacobian Ratio” below zero;Problem: “Run FEA” failed!;Solution 1 : change “Hub inlet z” to zero;Result : mesh success!;Solution 2 : reduce “Control Points” to 4;Solution 2 : reduce “Entry Slope”;Solution 2 : “Shroud Outer” default;Solution 2 : modify “Shroud Inlet” (red);Solution 2 : reduce “Extention Nodes”;Solution 2 : reduce “Shroud Fillet” ;Result : “ Run FEA ” success!;Solution 3 : Change “length unit” to m;Result : No change !;Solution 4 : Raise “Fillet radius” to 2;Result : Max reduce , but Min negative!;Solution 4 : Raise ???Fillet radius” to 4;Result : Max reduce , Min also negative!;Solution 5 : Change material; Result : Less change! ( r = 2 mm );Solution 6 : “ Include leading edge fillet ”; Result : “Jacobian Ratio” below zero!;Solution 7 : FEA by ANSYS( r = 2 mm );Solution 7 : “ Total Node Count ” equal;Result : Max stress is not wrong ！;V8.1.10;V8.1.11