变速器零件名称中文对照.docVIP

变速器零件名称中英文对照 序号 英文 中文 序号 英文 中文 1 fork, shift (1st 2nd) 1/2档拨叉 76 finger, control 控制臂 2 rail sub assay, shift (1st 2nd) 1/2档拨叉轴分总成 77 shaft, control 控制轴 3 sleeve, synchronizer (1st 2nd) 1/2档同步器外齿圈 78 boot, control shaft 控制轴防尘罩 4 hub, synchronizer (1st 2nd) 1/2档同步器转接套齿 79 housing, control 控制轴壳体 5 fork, shift (3rd 4th) 3/4档拨叉 80 shaft assy, control 控制轴总成 6 rail sub assy, shift (3rd 4th) 3/4档拨叉轴分总成 81 disc, clutch 离合器从动盘 7 hub, synchronizer (3rd 4th) 3/4档同步器转接套齿 82 cylinder assy, clutch release 离合器分离液压缸总成 8 fork, shift (5th rev) 5/R档拨叉 83 brg, clutch release 离合器分离轴承 9 rail sub assy, shift (5th rev) 5/R档拨叉轴分总成 84 housing, clutch 离合器壳体 10 hub, synchronizer (5th rev) 5/R档同步器转接套齿 85 clucth cover disc install 离合器压盘和从动盘安装 11 o-ring O型密封圈 86 cover assy, clutch 离合器压盘总成 12 seat 安装座 87 tube, clutch 离合器液压油管 13 gear, diff side 半轴齿轮 88 brkt, clutch fluid line 离合器液压油管支架 14 spacer, diff gear, thrust 半轴齿轮止推垫片 89 connecting parts dwg. 联接件图纸 15 t/m no. stamp procedure 变速器打号步骤 90 plug 螺堵 16 instal, t/m gskt 变速器垫片安装 91 nut 螺母 17 case,transmission 变速器壳体 92 bolt 螺栓 18 lubrication chart, transmission 变速器润滑图表 93 rivet 铆钉 19 t/m outside view 变速器外廓图 94 cap, sealing 密封盖 20 t/m assy dwg. 变速器总成图 95 bolt, seal 密封螺栓 21 brkt, corrugate clamp 波形夹子支架 96 washer, plain 平垫圈 22 gear set, differential 差速器齿轮组 97 brg, front 前轴承 23 spacer, diff side 差速器垫片 98 retainer, front bearing 前轴承保持架 24 case, diff 差速器壳体 99 bearing, ball 球轴承 25 pinion, differential 差速器行星齿轮 100 fork, shift (3rd4th) 三、四档拨叉 26 diff assy 差速器总成 101 rail, sub assy, shift 三、四档拨叉轴分总成 27 vehicle speed snar 车速传感器总成 102 gear, output 3rd 三档从动齿轮 28 bush 衬套 103 gear, 3rd speed 三档主动齿轮 29 magnet 磁铁 104 gear, clutch 3rd speed 三档主动齿轮齿圈 30 holder, magnet 磁铁固定器 105 gear assy, 3rd speed 三档主动齿轮总成 31 procedure of vin no marking 打印标记步骤 106 shaft, output 输出轴 32 bolt, washer assembled 带垫圈的螺栓 107 shaft, input 输入轴 33 spring 弹簧 108 collar, input 输入轴挡圈 34 washer, spring 弹簧垫圈 109 snap ring, input front 输入轴前端弹性挡圈 35 pin, spring 弹簧销 110 stud 双头螺栓 36 spring a