TL 528-2015大众塑胶电镀标准.pdfVIP

Group standard TL 528 Issue 2015-01 Class. No.: 55121 Descriptors: plastic part, chromium, chrome plating, metallization, plastic Chrome-Plated Plastic Parts Materials Requirements 4 Types: A, B, C, D Previous issues TL 528: 1965-01, 1973-09, 1979-01, 1985-01, 1986-06, 1988-06, 1993-06, 2000-07, 2006-04, 2008-06 Changes The following changes have been made to TL 528: 2008-06: – Table 1: PA6 removed (polyamide no longer permissible as a substrate) – Table 1, type B expanded – Table 1, type D: approval restriction on type D repealed – Section 3.1 Basic requirements: Resistance to open-air weathering added – Section 3.2.1 Base material and Section 3.2.2 Appearance and stress of the blank expan‐ ded – Section 3.3.1 Surface finish, Section 3.3.3 Coating procedure, and Section 3.3.4 Techno‐ logical requirements for the coated part revised – Table 2 completely revised – Section 4 Requirements for supplier production monitoring new – Section 5.1 Coating system revised – Section 5.2 Measuring points of coating thicknesses, micro-discontinuities, differences in po‐ tential new – Section 5.3 Cross-cut test (St. Andrews cross) revised and figures 1 and 2 added – Section 5.4 Performing the salt spray test added Always use the latest version of this standard. Page 1 of 15 This electronically generated standard is authentic and valid without signature. The English translation is believed to be accurate. In case of discrepancies, the German version is alone authoritative and controlling. Technical responsibility The Standards department GQL-P/1 M