WSS-M1P83-D1-2011福特塑胶电镀标准.pdfVIP

ENGINEERING MATERIAL SPECIFICATION ELECTROPLATING, BRIGHT OR LOW GLOSS DECORATIVE FINISH WSS-M1P83-D1 OVER ABS, PC/ABS OR NYLON FILLED – INTERIOR 1. SCOPE This specification defines the performance requirements for finished coatings of mechanically or chemically deposited electrical conductor coat and electrodeposited copper, nickel, and chromium for the decoration and protection of acrylonitrile butadiene styrene (ABS) or polycarbonate/acrylonitrile butadiene styrene (PC/ABS) or filled nylon (PA) parts. 2. APPLICATION This specification was released originally where a bright or low gloss decorative and/or protective finish is required for interior parts. Unless otherwise specified on the engineering drawing, all parts shall be finished with a final coating of chromium. 3. REQUIREMENTS All requirements identified for each specification must be met to achieve acceptable field durability. No one requirement, exclusive of others, is capable of insuring satisfactory performance. Any deviations to the requirements of these specifications may be subject to additional performance requirements. All part testing requirements apply to those areas of the part identified as a significant surface (per paragraph 4.3) unless otherwise specified on the engineering drawing. Testing to be done a minimum of 72 hours after plating. 3.1 STANDARD REQUIREMENTS FOR PRODUCTION MATERIALS Material suppliers and part producers must conform to the Companys Standard Requirements For Production Materials (WSS-M99P1111-A). 3.2 FINISHED PARTS