用油漆罐自制斯特林.docVIP

如何使油漆罐斯特林发动机Assembly Instructions (1)Make the Pressure ChamberThe finished pressure chamber will be 1 1/2” tall.??It will be made from the top and the bottom of the paint can. Remove the paint can lid and mark a line around the side that is exactly 5/8 down from the top.??Mark another line around the outside that is exactly 5/8” up from the bottom.??Cut carefully along this line.??Cut carefully so that you also preserve the center section of the can.??You are going to use the center section to cut some additional parts. I use a sheet metal nibbler to cut my paint cans.??I drill a small