汽车线束端子接插件应用介绍.pptVIP

* * * page * Degrees of Protection against Water (GB 4208) 防水等级(GB 4208) page * Degrees of Protection against Water (IP Code DIN40050) 防水等级(DIN 40050) IPX.1/ IPX.2 page * Degrees of Protection against Water (IP Code DIN40050) 防水等级(DIN 40050) IP X.3/ IP X.4/ IP X.4K page * IP X.5/ IP X.6/ IP X.6K Degrees of Protection against Water (IP Code DIN40050) 防水等级(DIN 40050) page * IP X.7/ IP X.8/ IP X.9K Degrees of Protection against Water (IP Code DIN40050) 防水等级(DIN 40050) page * Sensor Connector 1 visual inspection 2 contact resistance 3 watertight sealing(air blowing up to 98kPa) 4 thermal shock(-50 to +120°C, 100h) 5 contact resistance 6 watertight sealing(air blowing up to 29.4kPa) 7 watertight splash(IPX.9K) Superseal 1.5 　 Group 1 Group 2 1 visual inspection visual inspection 2 insluation resistance heat aging( 125°C) 3 IP X.6K /IPX.9K water resistance(30min,0.01bar pressure) 4 insluation resistance insulation resistance MCON 1.2 Connector 1 visual inspection 2 rapid change of temperature( -40 - 130°C) 3 protection agaist water(air blowing up to 600mbar) 4 IPX.4K/IP X.9K HDSCS Connector 1 visual inspection 2 pre-aging(120/-40°C, 500h/120°C,120h/140°C ) 3 IP 67/IP 69K 4 visual inspection Superseal 1.0mm Connector 　 Group 1 Group 2 1 visual inspection visual inspection 2 insulation resistance IP X.9K( leak current) 4 sealing test:air blow up to 98kPa, leak current(28V,100uA) 　 5 visual inspection 　 154P(94+60) Connector 1 visual inspection 2 IP X.9K 3 thermal shock(-40 to +130°C) 4 IP X.9K 5 water bath test( air blow up to 60kPa) 6 water immersion after temperature change Sealing Test for Common Connector 常用连接器防水测试 Validation of Sealing Behavior 验证密封性能 Analyze the seal shape, contact pressure by CAE. CAE模拟接触压力 Measure the sealing pressure by tests. 实验室进行气密性测试 Stress Contact Pressure * Wire / Cavity Seals: SWS Family Seal Peripheral Seals: Radial Seal Face Seal L shaped peripheral seal interference positioning The SWS is placed on the wire at a defin