HyperMesh支持不同求解器的资料.pdfVIP

Lab 2 Finite Element Analysis of a Cantilever Beam y P = 40000 lb. 12 in. x 96 in PROBLEM STATEMENT Consider a 96 in. x 12 in. cantilever beam as shown in the above figure. The beam is loaded at the right end by a force P = 40000 lb. The beam is isotropic with Young’s modulus E = 3x107 psi and Poisson’s ratio ν = 0.3. Using Hypermesh and ABAQUS, perform the analysis outlined below. Start out by creating a relatively coarse mesh of 4-node quadrilateral elements (try a mesh of rectangular elements with 6 divisions in the x direction and 2 divisions in the y direction). Apply the appropriate boundary conditions, and run the problem assuming plane stress. Instructions for Lab#2 Using Hypermesh and ABAQUS for the analysis of a beam in bending. Figure 1. Main W indow in Hypermesh. Circled is the command toolbar that allows the user to access sub menus. Getting Acquainted 1) Fire up Hypermesh from the menu controls. 2) Familiarize yourself with the command toolbar to your right. By clicking next to each title as circled above, you will be brought to several sub-menus where you may perform a variety of tasks. Click on each and analyze each sub-menu. 3) Identify commands that appear self-explanatory, such as file, automesh, nodes, lines, ect 4) Notice that the file command exists in every toolbar. 5) Click on the file command. This is where you name the hypermesh files y