惠普Procurve以太网交换机配置指南-Version-1.0.docxVIP

中国惠普有限公司 2011年 2011 惠普ProCurve以太网交换机安装配置指南 Version1.0 惠普ProCurve以太网交换机安装配置指南 中国惠普有限公司安装规划中心 产品介绍 ProCurve 6120系列交换机分为两种型号： 6120G/XG 6120XG 产品名称的规则： 以6120产品的G/XG为例，G和XG都指端口速率，其中G表示1Gb per second，XG表示10Gb per second； ”/”以前的部分特指内部端口速率，”/”以后的部分特指外部端口速率。 前面板及端口介绍： 端口 6120 G/XG 6120 XG 端口类型 端口名称 端口类型 端口名称 16x 1GbE Server NIC ports D1-D16 16x 10GbE Server NIC ports 1-16 1x 10GbE CX4 C1 1x 10GbE CX4 or 1x 10GbE SFP+（最左侧） 17 2x 10GbE XFP ports X1;X2 5x 10GbE SFP+ ports 18;19;20;21;22 2x 1GbE SFP ports S1;S2 2x 10GbE SFP+ ports or S2S links（最右侧） 23;24 4x 10/100/1000 RJ-45 ports 1;2;3;4 　 　 S2S link I1 　 　 Management Port OOBM Management Port OOBM 10GbE CX4—The CX4 interface requires the use of copper cabling, similar to the variety used in InfiniBand technology, and is designed to work up to a distance of 15?m. CX4 technology is an attractive solution because it has the lowest cost per port of all 10Gb interconnects, at the expense of range. CX4 has a bigger form factor than either SFP or SFP+. 10GbE XFP ports—These 10GbE ports support SR (multi-mode fiber, 300 m) and LR (single-mode fiber, 10 km) optic transceivers based on the XFP version of the small form factor pluggable specification. XFP transceivers have a smaller form factor compared to several standards (XENPAK, X2, XPAK) that preceded it. The XFP ports support Industry Standard Servers (ISS) optics only. 1GbE SFP ports—These 1GbE ports support SX (multi-mode fiber, 550 m) and LX (single-mode fiber, 10 km) optic transceivers based on the SFP version of the small form factor pluggable specification using an LC physical connector. These ports also support 1000BASE-T copper connections using an RJ-45 connector. The SFP ports support ISS and ProCurve optics. 10/100/1000 RJ-45 ports—These ports support standard RJ-45 Ethernet cables and each port can operate at one of three autosensing speeds. 5x 10GbE SFP+ ports—These five ports are dedicated10GbE SFP+ ports that support SR (multi-mo