DFM案例分析讲解学习.pptVIP

产品1：这个产品还有一件镜像体，这里不重复分析。 70.67 2.64 Part 1: RH and LH is mirrored so only one of it is shown in this report. 注意，本文件底色绿色部分的翻译文本为比较合适的表述效果。 镶针深入0.10MM封胶，避免出披锋。 To avoid occur flash ,suggest to let insert go deep into seal off surface 0.01mm Suggest to create a 0.1mm concave at core (cavity) steel for the pin insert seal off in order to optimize/improve the flash direction, if any. Improve: 改善 Optimize：优化 Tuning：调整 ,if any: 如果有的话 In case 如图，红色部分出前模，产品减胶0.05MM Indicated red surface for cavity,suggest to remove material 0.05mm 分型面与骨位底面平行 PL surface be parallel to the bottom surface of rib The surfaces in red is formed by the cavity which need to create positive draft by removing material, max. 0.05mm Positive：正面的 Negative: 负面的 Draft: 出模角 MMC: Maximum Material Condition Parting line will be in parallel to the bottom surface this rib. 所指红色面直身，建议往前模加胶拨模2度，最大加胶0.06MM 详见修改后的产品3D 所指红色面倒扣，建议往前模拨模0.3 度，最大加胶0.19MM 详见修改后的产品3D 所指红色面倒扣，建议往前模加胶拨模2度，最大减胶0.13MM 详见修改后的产品3D Indicated red surface without draft angle,suggest to apply 2 degree at the cavity side,max. material added is 0.06mm,more details refer to modified part 3D Indicated red surface is undercut, suggest to apply 0.3 degree at the cavity side by adding material,max. material added is 0.19mm,more details refer to modified part 3D Indicated red surface is undercut, suggest to apply 2 degree at the cavity side by removing material,max. material removal is 0.19mm,more details refer to modified part 3D There is no draft in the red surfaces, suggest to apply 2 degree in cavity direction by adding material, max. material added is 0.06mm, please refer to part 3D data updated/modified by us. Update: 升级 Modify: 更改 Latest=updated: 最新 Undercut in red surface as indicated…. 所指红色面倒扣，建议往行位减胶拨模2度，最大减胶0.05MM 详见修改后的产品3D 为避免行位薄钢建议所指红色面加胶到行位分型面，最大加胶0.09MM 详见修改后的产品3D 为避免行位薄钢建议所指红色面加胶到行位分型面，最大加胶0.05MM 详见修改后的产品3D Suggest to add material into parallel with PL to avoid slide too thin, max. material added is 0.09mm,more details refer to modifi