稻草纤维增强加气混凝土制备工艺研究.pdfVIP

学兔兔 全国中文核心期刊 新鬼建巍 中国科技核心期刊 稻草纤维增强加号混凝土制吾工艺研奔 李方贤 ，周成“z，张海东 ，贺大东 (1．华南理工大学 材料科学与工程学院，广东 广州 510640； 2．广东省建筑材料低碳技术工程技术研究中心，广东广州 510640 3．华南理工大学 建筑学院，广东广州 510640) 摘要：研究了利用稻草纤维制备加气混凝土的工艺参数。结果表明：稻草纤维掺量低于3％时，对加气混凝土浆体起到增强增韧 效果；随着稻草纤维掺量的增加，浆体的流动度降低，料浆的发气高度也逐渐降低，料浆初始流动度为155～160 mm，发气速度与稠化 速度匹配，制备的加气混凝土强度较高，密度较小；预养护温度过低和过高都不利于发气，45 qC为最佳预养护温度。 关键词：稻草纤维；加气混凝土；发气；流动度 中图分类号：TU528．2 文献标识码：A 文章编号：1001—702X(2016)01—0040—03 Study on preparation of straw fiber reinforced aerated concrete LI Fangxian ，ZHOU Cheng1 ，ZHANG Haidong ，HE Dadong3 (1．College of Materials Science and Engineering，South China University of Technology，Guangzhou 510640，China； 2．Low Carbon Technology Engineering Research Center for Building Materials of Guangdong Province，Guangzhou 510640，China； 3．School of Architecture，South China University of Technology，Guangzhou 510640，China) Abstract：The parameters of preparing aerated concrete with straw fiber were studied．The results showed that the strength and the toughness of aerated concrete slurry were increased as the content of straw fiber was less than 3％．The fluidity of slurry and the initial gas forming rate were all decreased with increasing the straw fiber content．The rate of gas forming and multi—vis— cosity matches well when the initial fluidity of slurry was between 155 and 160 mm and the aerated concrete obtains a higher strength and a lower density．A high or low pre—curing temperatures was detrimental for the rate of the gas forming and the opti— mum pre—curing temperature Was 45℃． Key words：straw fiber，aerat