美国材料协会标准 A767 - A 767M - 19.pdfVIP

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. Designation: A767/A767M − 19 Standard Specification for Zinc-Coated (Galvanized) Steel Bars for Concrete Reinforcement1 This standard is issued under the fixed designation A767/A767M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (´) indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the U.S. Department of Defense. 1. Scope* 2. Referenced Documents 1.1 This specification covers steel reinforcing bars with 2.1 ASTM Standards:2 protective zinc coatings applied by immersing the properly A90/A90M Test Method for Weight [Mass] of Coating on prepared reinforcing bars into a molten bath of zinc. Iron and Steel Articles with Zinc or Zinc-Alloy Coatings A615/A615M Specification for Deformed and Plain Carbon- NOTE 1—The galvanizer is identified throughout this specification as Steel Bars for Concrete Reinforcement the manufacturer. A706/A706M Specification for Deformed and Plain Low-