kmx磨床充退磁控制器英文说明书.docVIP

Xi’an Mingshi Electro Mechanical Development Co., Ltd. TEL: 029 FAX: 029KMX-TYPE MAGNETIZING AND DEMAGNETIZING CONTROLLER FOR ELECTROMAGNETIC SUCKING DISC OF GRINDER INSTRUCTION XI’AN MINGSHI ELECTRO MECHANICAL DEVELOPMENT CO., LTD. 1. OVERVIEW Magnetization and demagnetization have been bothering the surface grinder plants and users. The conventional magnetizing/demagnetizing method is through switch manual-control with transformation and rectification ,　this method is not only low efficiency in operation but also the magnetizing /demagnetizing effect is not obviously. Especially for the alloy or the material which was being heat treated they have a lot of residual magnetism , which affects the machining accuracy and efficiency, limited the machining range of surface grinder, Conventional magnetizing/demagnetizing method is not unsatisfy the requirement of modern machine industry for the equipment. For resolving these problems, KMX series magnetizer/demagnetizer are be designed and produced by XI’AN MINGSHI ELECTRO MECHANICAL DEVELOPMENT CO., LTD. meticulously. It’s resolved above problem effectively. The basic functions of the products are below: 1. Using integrated circuit control, output without contact, reliability is high. 2. The magnetizing current can be adjusted continually, it means magnetic force can adapt to different electromagnetic sucking disc of grinder for machining different workpieces. 3. The demagnetizing process is automatically finished according to the demagnetizing curve, the effect of demagnetization is best. 4 .The demagnetizing time is adjustable. 5. Against over-voltage, over-current and short-circuit etc. 6. The main controller and the electromagnetic disc can take effect interact against under current, this function can be against under magnetism, thus the safety of operator and equipments can be got. 7. Small size, installation and testing is convenient. 2. TYPE AND TECHNICAL PARAMETER Type Rated input