液压管工作压力计算公式Hydraulic Tubing.pdfVIP

___________________________________________________________________________ PRESSURE RATING OF HYDRAULIC TUBING Burst pressure There a three commonly used formulas for calculating the burst pressure of seamless hydraulic tubing: Barlow formula P = 2 × T × S D Boardman formula P = 2 × T × S D − (0.8 × T) Lame formula P = S × (D² − d²) (D² + d²) Where P = burst pressure in psi T = nominal wall thickness of tubing in inches S = minimum ultimate tensile strength of tube material in psi D = nominal outside diameter of tubing in inches d = nominal inside diameter of tubing in inches Working pressure Once the burst pressure of the tube has been calculated, working pressure is calculated using the following formula: WP = P ÷ sf Where WP = working pressure in psi P = burst pressure in psi sf = design safety factor (3 minimum recommended) HydraulicS 2000 - 2003  By downloading this document you acknowledge acceptance of our Terms and Conditions of Use ___________________________________________________________________________ Reference working pressures The following table lists working pressures in psi of seamless steel tube calculated using Barlow’s formula, based on a minimum ultimate tensile strength of 50,000 PSI and a design safety factor of 4:1: Nominal tube Nominal tube wall thickness (in.) OD (in.) 0.028 0.035 0.049 0.065 0.083 0.095 0.109 0.120 0.134 1/8 0.125 5600 7000 3/16 0.188 3750 4650 1/4 0.250 2800 3500 4900 6500 5/16 0.312 2250 2800 3900 5200 3/8 0.375 1850 2350 3250 4350 1