sph-常用关键字手册.docxVIP

1.*CONSTRAINED_GLOBAL 全局约束 Purpose: Define a global boundary constraint plane. 定义一个全局平面边界约束 TC Translational Constraint: 平动约束 EQ.1: constrained x translation, EQ.2: constrained y translation, EQ.3: constrained z translation, EQ.4: constrained x and y translations, EQ.5: constrained y and z translations, EQ.6: constrained x and z translations, EQ.7: constrained x, y, and z translations, RC Rotational Constraint: 转动约束 EQ.1: constrained x-rotation, EQ.2: constrained y-rotation, EQ.3: constrained z-rotation, EQ.4: constrained x and y rotations, EQ.5: constrained y and z rotations, EQ.6: constrained z and x rotations, EQ.7: constrained x, y, and z rotations. DIR Direction of normal 正常的方向 EQ.1: global x, EQ.2: global y, EQ.3: global z. X x-offset coordinate x方向偏移坐标 Y y-offset coordinate y方向偏移坐标 Z z-offset coordinate z方向偏移坐标 Remarks: Nodes within a mesh-size-dependent tolerance are constrained on a global plane. This option is recommended for use with r-method adaptive remeshing where nodal constraints are lost during the remeshing phase. 节点网格大小的依赖公差限制在全局坐标平面上，这个选项要求使用在 适应的重新划分 节点约束消失在重新划分阶段。 z z y y xzx x z x 举例说明：(多用在对称面处) *CONSTRAINED_GLOBAL *CONSTRAINED_GLOBAL 1 5 1 X平动 Y、Z转动 X法线方向 3 4 3 Z平动 X、Y转动 Z法线方向 2. *SECTION_SPH SPH属性设置 Purpose: Define section properties for SPH particles. 定义SPH粒子的属性 SECID SECID is referenced on the *PART card. A unique numberor label not exceeding 8 characters must be specified. 使用特定的PART编号，其号码字符不能超过8个字符。 CSLH Constant applied to the smoothing length of the particles. The default value applies for most problems. Values between 1.05 and 1.3 are acceptable. Taking a value less than 1 is inadmissible. Values larger than 1.3 will increase the computational time. The default value is recommended. 该常数用于设置光滑粒子长度，默认值应用于大部分问题。设定值在1.05~1.3之间是可行的，值小于1不可行，值大于1.3会增加计算时间，建议取默认值。