双丝电弧喷涂中粒子交叉飞行行为的在线测量及分析-中国表面工程.pdf

18 5 Vol.18 No.5 2005 10 CHINA SURFACE ENGINEERING October 2005 ( 100072) SprayWatc−2i (EDS) () 10 % TG174.442 A 1007−9289(2005)05−0012−04 On Line Measurement and Analysis of Cross Flying Behavior in Twin Wire Arc Spray LI Zhan-mingZHU You-liYE Xiong-linDU Xiao-kun (Faculty of Remanufacture Engineering, Academy of Armored Forces Engineering, Beijing 100072, China) Abstract: Using two consumable wires of different melting point as anode and cathode in high velocity arc spraying process, the ‘cross flying’ behavior of particles from the twin wires was demonstrated directly by on line measurement and analysis of particles average temperature distribution by a Spray Watch-2i thermal spray monitoring device. The distribution of oxides and materials from the twin wires in the spray deposit was measured quantitatively by energy dispersive spectrum analysis. The results showed that, across the deposit, the flattened particles from the anode and cathode distributed unsymmetrically around the spray jet center. In the investigated spray distance, the content of various composition (including oxides) varied insignificantly with spray distance. In the electric arc spray coating the oxide content was about 10 %. Key words: arc spray; cross flying; particle; temperature 0