GMW3172_Packaging Tests_RandomVibration通用包装随机震动测试.pdfVIP

GM WORLDWIDE ENGINEERING STANDARDS Template For ENG STDS GMW3172 10.2 Electrical. There are no new Electrical procedures for PV. All Electrical procedures are defined in the Development and Design Validation sections. See Table 5 Summary of A/D/V Activities for applicable procedures for PV. 10.3 Mechanical. Shipping Vibration is the only new Mechanical procedure for PV. All other Mechanical procedures are defined in the Development and Design Validation sections. See Table 5 Summary of A/D/V Activities for applicable procedures for PV. 10.3.1 Shipping Vibration. Purpose: This test shall verify the robustness of the component together with the packaging during shipping. Applicability: All components (with and without surfaces visible to customers) where the component supplier is responsible for container design. Note: When GM is responsible for container design, the component supplier is responsible to provide components and any applicable supplier designed inserts to be tested. Operating Type: 1.1 Monitoring: Not applicable Procedure: Use a vibration test fixture that allows the shipping container to move freely in the vertical axis of the vibration table. One possible fixture consists of a base plate with four upright posts that are slightly larger than the shipping container. Provisions shall be made to allow placement of the shipping container in all three directions. 1 Vibrate the shipping container for 24 h in each of the three mutually perpendicular directions using the methods outlined in ASTM D4728, Standard Test Method for Random Vibration Testing of Shipping Containers. If a supplier can use a vibration table with 6 Degrees Of Freedom, then the test can be run for 24 h only once. This test shall be performed on one fully-populated containe