AASHTO 间接拉伸方法测定沥青混合料的动态模量.pdfVIP

Proposed Standard Test Method for Determining the Dynamic Modulus for Hot-Mix Asphalt (HMA) Using the Indirect Tension Testing Method AASHTO Designation: TP XX-XX 1. SCOPE 1.1 This standard describes the test method for measuring the dynamic modulus for hot- mix asphalt mixtures using the indirect tension testing method. This practice is intended for dense- and gap- graded mixtures with nominal maximum aggregate sizes to 25 mm. 1.2 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this procedure to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to its use. 2. REFERENCED DOCUMENTS 2.1 AASHTO Standards • AASHTO PP XX-XX, Preparation of Indirect Tension Performance Test Specimens Using the Superpave Gyratory Compactor • AASHTO PP XX-XX, Developing Dynamic Modulus Master Curves for Hot- Mix Asphalt Concrete Using the Simple Performance Test System 2.2 Other Publications • Equipment Specification for the Simple Performance Test System, Version 3.0, Prepared for National Cooperative Highway Research Program (NCHRP), October 16, 2007. • Barksdale, R.D., J. Alba, N.P. Khosla, Y.R. Kim, P.C. Lambe, and M.S. Rahman, Laboratory Determination of Resilient Modulus for Flexible Pavement Design, Final Report, National Cooperative Highway Research Program 1-28 Project, June 1997. • Kim, Y.R., Y. Seo, M. King, and M. Momen. Dynamic Modulus Testing of Asphalt Concrete in Indirect Tension Mode. In Transpor