瓦锡兰主机RT_flex资料之二(彩色).pptVIP

? W?rtsil? Land Sea Academy Page * Chapter 40 * The control oil pump(s) supply an oil pressure of 200 bar to operate injection control valves and to prime the servo oil rail (with reduced pressure), when the engine is at standstill. Control oil pressure is adjusted at pressure retaining valves on the control oil block. A dry-run protection in case of low bearing oil pressure is provided within the WECS-9520 software. Bosch Pumps: From standstill until 50% engine load both pumps are running. At higher engine speed one of the pumps is switched off and restarts only if the control oil pressure delivered by the remaining pump drops below 170 bar. Dynex Pumps Always one pump is running over the entire engine load range. In single pump mode, the active pump changes after each new start to the stand-by pump to have similar operating hours on both pumps. Control Oil Pressure Control ? W?rtsil? Land Sea Academy Page * Chapter 40 * The opening and closing of the starting pilot valves 2.07 is controlled by the corresponding FCM, depending on the crank angle. The nominal opening angle is 0°, closing angle is 110°. For engines with a large cylinder number the closing angle can be reduced in order to save starting air. The automatic starting valve 2.03 is activated by solenoids ZV70113C and ZV7014C via FCM-20 #1 and FCM-20 #2, if the remote control sends a START signal over the bus. For slow turning and slow turning failure reset the remote control sends separate signals to FCM-20 #1 and FCM-20 #2. The slow turning speed can be adjusted in the WECS-9520 parameters by adopting pulse cycles. Additionally an Air Run signal enables to blow the engine with start air. Starting Valve Control 2.07 2.03 ? W?rtsil? Land Sea Academy Page * Chapter 40 * Starting Valve Control 知识回顾Knowledge Review To show the scope of supply of W?rtsil? ? W?rtsil? Land Sea Academy Page * Chapter 40 * Standard System CA 2 Control Room WECS-9520 Serviceport CANopen or ModBus #1 Module Bus