MSA-GRR分析表单(单张).xlsVIP

GRR分析 Capt Capture.Capture GoA1 Part Certification ? Date NAME A R Supplier Part number B C Plant Units P Average Range T REPEATIBILITY AND REPRODUCIBILITY ANALYSIS REPORT Method used Total count NON DESTRUCTIVE TEST Button K1 - 1 (trials) Button K2 - 1 (appraisers) Button K3 - 1 (parts) PLEASE SPECIFY THE FOLLOWING PARAMETERS AND COMPLETE THE FORM ACCORDINGLY PARAMETERS ARE K1 Trials K1 Number of Trials Must be either 2 or 3 k2 Appraisers K2 Number of Operators K3 Parts K3 Number of Parts Can be any value between 2 and 10 count max must improper !! Error Msg stg above UCLr Out of UCL A1 A2 Part name A3 Characteristic Gage number Coord by A4 Tolerance Gage name Phone # A5 Gage ECL/revision A6 A7 OPERATOR RESULTS A8 TRIAL # AVG A9 A1 A10 A2 B1 A3 B2 XA B3 RA B4 B1 B5 B2 B6 B3 B7 XB B8 RB B9 C1 B10 C2 C1 C3 C2 XC C3 RC C4 Part Avg xPART = C5 Part Range RPART = C6 R = RA+ RB + RC / No of operators = + / C7 XDIFF= [Max (X)ABC] - [Min (X)ABC] = - XDIFF = C8 UCLR= * D4 = UCLR = C9 LCLR= D3 = LCLR = C10 NOTE: It has been statistically proven that the Tolerance Method is better Errors_sum to determine measurement equipment reliability. Even with negative Kurtosis data sets, the recorded measurements will be less than 1% away from the true value if GRR is below 30%. Contact Quality Group if you GOOD UNTIL GAGE ECL/revision CHANGE need more information. FROM DATA SHEET: XDIFF = RPART = Measurement Unit Analysis Repeatibility - Equipment Variation (EV) EV = R * K1 Trials % EV = Reproducibility - Appraiser Variation (AV) AV= [ ( XDIFF * K2)2 - (EV2 / nr)] (n parts, r trials) Oper % AV = Repeatibility Reproducibility (R R) RR= (EV2 + AV2) % RR = Part Variation (PV) PV= RPART * K3 Parts % PV = Total Variation (TV) TV= (RR2 + PV2) DETERMINE THE RISK PRIORITY NUMBER (RPN) FROM THE FMEA ASSOCIATED BREAKPOINT = RPN # x %GRR/100 WITH THE DIMENSION BEING GAGED. TYPE THE RPN # UNDER THE RPN # FIELD PROVIDED (RIGHT) AND FOLLOW INSTRUCTION OF USAGE IN NEXT ROW: Guidel