《某城市道路施工图设计》-毕业设计(论文).docVIP

摘要 PAGE IV 某城市道路施工图设计 摘 要 从设计中，主要是进行某中等城市道路施工图设计。设计部分的道路全长2742.8m，设计车速60km/h，双向六车道，全程设置中央分隔带。 对交通量进行了分析，查找相应技术规范，确定城市道路的等级以及设计所需的各种参数，在平面图中进行选线，然后又对道路路线进行了平面线形设计，本路线有三段圆曲线，且没有设置缓和曲线和标高。纵断面的设计中有三个竖曲线，并且也满足了平纵面线形组合设计中的各种要求。在横断面的设计中，确定了横断面组成及各种要素后，绘制横断面图。交叉口设计的基本内容就是确定交叉口形式。路面设计内容中包括路面类型与结构设计。 通过这次设计不但了解建设城市道路的各个步骤，而且也能熟练地运用AUTOCAD进行制图。 关键词：交通量，线形设计，路面结构，交叉口 A New Expressway Construction Of A City ABSTRACT In this design,is mainly the dongshen expressway design,the length of this road which we design is 2742.8m, the design of the speed is 60km/h and set up the central of separation strip. 英文摘要须与中文摘要内容相对应，英文摘要约250个实词；关键词要反映毕业设计说明书（论文）的主要内容，数量一般为3-5个。 Design, road construction drawings and design of a medium-sized cities. The design part of the road length of 2742.8m, a design speed of 60km / h, six-lane two-way, the entire set of central reserve.Traffic, find the corresponding technical specifications to determine the level of urban roads as well as design the various parameters required in the line selection in the plan, then the horizontal alignment design of the road route, the route there are three sections of circular curve and set the transition curve and elevation. The design of the vertical section of the three vertical curves, and also to meet the various requirements in the design of the linear combination of the flat vertical surface. In the cross-sectional design to determine the cross-sectional composition and the various elements, draw a cross-sectional diagram. Intersection design is to determine the intersection form. Content of pavement design, pavement type and structural design.Through this design not only understand the various steps of the construction of urban roads, but also skilled in using AUTOCAD drawing. KEY WORDS: 关键词1，关键词2，关键词3，关键词4，关键词5 前言 目　录 TOC \o 1-3 \h \z \u 前　言 1 第1章 标准横断面设计 2 1.1 道路路幅设计 2 1.2 机动车道设计 2 1.3 非机动车设计 2 1.4 车行道的路拱和横坡度 2 1.5 人行道设计 2 1.6 绿化带设计 2 1.7 管线布置 2 1.8 横断面综合布置 2 第2章 平面线形设计 3 2