横河cs3000功能块说明1.pdfVIP

横河CS3000功能块说明 Toc Ind D1. Regulatory Control D1-1 IM 33S01B30-01E D1. Regulatory Control调整控制 The regulatory control performs control computation processing using analog process values for process monitor and process control. The function blocks that provide the regulatory control function are referred as regulatory control blocks.”调整控制是利用过程监控及过程控制中的模拟过程 量来进行控制计算处理的。 This chapter presents a detailed description of the function of each of the regulatory control blocks, excluding the Foundation Fieldbus faceplate block. 这章将逐个介绍每个调整控制块的功能，包括基金会现场总线的面板功能 块。 SEE ALSO参阅 For details on the Foundation Fieldbus faceplate blocks, see chapter A2, Overview of FF Faceplate Blocks” in the Foundation Fieldbus Reference (IM 33Y05P10-01E). 了解基金会现场总线面板功能块的详细情况，请参照关于FF部 分的A2章节“FF面板功能块的概述” Regulatory Control Positioning ¡ 调整控制的配置 The regulatory control is one of the basic controls in the FCS and performs control computation processing to monitor and control processes. The function blocks that perform the this regulatory control are referred as regulatory control blocks.” 调整控制是FCS的一个基本控制单元，执行过程监控的控制计算处理。我们把执行 这个调整控制的功能块称之为调整控制块。 The regulatory control blocks include Input indication blocks, controller blocks, manual loader blocks, signal set blocks, signal limiter blocks, Signal selector blocks, signal distribution blocks, pulse-count blocks, alarm blocks and YS blocks. The figure below shows the position of the regulatory control function in the basic control architecture: 调整控制功能块包括输入控制块，控制器块，手动设备块，信号设置块，信号限制 块，信号选择块，信号分布块，脉冲计数块，报警块和YS 块。 下图说明调整控制功能块在基本控制体系的位置： D1.1 Regulatory Control Blocks调整控制块 The regulatory control blocks are the function blocks that perform control computation processing mainly on the analog input as input signals. The calculated results are used for process monitor and process control.调整控 制块主要是一种主要以模拟输入作为输入信号进而执行控制计算处理的功能块。计 算结果用于过程监控和控制。 The regulatory control blocks support the following