ACF系统举例总体介绍.pptVIP

报警信息行 信息列表 操作提示 8 优先级- 颜色- 确认 15 厂域 面板弹出与操做 .wav 文件用于语音报警 报警管理 DigiVis 三级层次 系统 过程站 模件 自动生成 完整系统监控 指示 温度报警 输出强置 硬件信息 运行时间 CPU 负载 系统诊测 DigiVis 大成日研糖醇 开发有限公司 山梨醇项目DCS系统结构图 操作员站 工程师站1 冗余ProfiBus DP 现场总线 12MB/S I/O站 （7个） 打印机 操作员站1 工业以太网 100Mb/s 打印机 I/O站 （6个） 冗余控制器 冗余控制器 操作员站3 操作员站5 操作员站 工程师站2 Recently released functionality 16 MB CPU for AC 800F LD 800HSE support- Foundation Fieldbus HSE Linking device redundancy FDT/DTM 1.2 – nested DTM (for HART) Auto Router und Comment-Block for FBS User defined trend display for DigiVis OPC for Profibus HART Structured Text - 5th programming language Audit Trail Server DigiVis with dual monitor support as of V7.2 Optimized Profibus redundancy as of V7.2 Roadmap * * * * AC800F 为冗余功能的现场总线控制器 CPU 主频为 75MHZ； * Redundancy Link Module 01 creates a redundant Profibus DP line by switching line A or line B to the single line on a message base. In the other direction it doubles messages from the single line to line A and line B Linking Device 800P converts the low bandwith PA bus to the high speed DP bus, thus allowing for connecting intelligent PA devices to the same bus as fast remote I/O without loosing the advantage of a high speed bus. OPC server gives client application access to DPV1 parameters (Asset Optimization) FDT/DTM V1.2 Technology is the Windows printer driver for the field device * * Linking Device 800HSE connects the low speed H1 world via High Speed Ethernet (10/100 MBaud) to the controller. The controller features the new FI 840F HSE module for this connection. Release planned by mid of December with V7.1SP2a Max 10 LD 800HSE allowed on one FI 840F Max 400 Signals per second allowed on one HSE network Max 80 Signals per second allowed for one LD 800HSE LD 800HSE allows for control in the field without the need for a DCS controller by supporting publish/subscribe communication between the H1 segments as well as between the linking devices. All supported by the all-in-one configuration and commissioning