是小型记忆卡的一种.ppt

12/13 DSD Project Presentation 第四組 SD IO Interface World Real Time Clock / Alarm with C-LCM SD / SDIO Card SD Memory Card Functional Description Command Command Types All commands have a fixed code length of 48 bits SD Memory Card Functional Description Cyclic Redundancy Code (CRC) SPI Mode SPI Mode Transaction Packets －Command Tokens CMD0 SPI Mode SPI Mode Transaction Packets CMD5 The IO_SEND_OP_COND Response (R4) An SDIO card receiving CMD5 shall respond with a SDIO unique response, R4. The format of R4 for both the SD and SPI modes is: CMD8 Introduction to CMD8 SEND_IF_COND (CMD8) is used to verify SD Memory Card interface operating condition. The card checks the validity of operating condition by analyzing the argument of CMD8 and the host checks the validity by analyzing the response of CMD8 (See Chapter 4.3.13). Format of Response R7 This response token is sent by the card when a SEND_IF_COND command (CMD8) is received. The response length is 5 bytes. The structure of the first (MSB) byte is identical to response type R1. The other four bytes contain the card operating voltage information and echo back of check pattern in argument and are specified by the same definition as R7 response in SD mode. CMD52 Value of R5(CMD52) R/W=1, RAW=1: The value read from the addressed register. In this case, the read-back data may not be the same as the data written to the register, depending on the design of the hardware. R/W=1, RAW=0: the data in this field shall be identical to the data byte in the write command. R/W=0: the actual value read from that I/O location is returned in this field. Common I/O Area Structure Card Command Control Register Common I/O Area Structure Function Basic Register (FBR) Function 1-7 Register Mapping Function 用法 Function 1 Function 1 : 設定時間 Address 0x0000 reset_rtc0x0001 TH0x0002 H0x0003 TM0x0004 M0x0005 TS0x0006 S Function 2 Function 2 :切換時區 Address 0x0000 change_city 0x0001 city0