T6时效和T6I6时效对6005A铝合金微观组织和性能的影响.pdfVIP

22 5 2012 5 Vol.22 No.5 The Chinese Journal of Nonferrous Metals May 2012 1004-0609(2012)05-1276-07 T6 T6I6 6005A ( 410083) (TEM) (HRTEM)6 T6I6 6005A 6005A T6 175 12 h 120 HV100 μm T6I6 (127 HV)30 μm 6005A β″ TG 146.21 A Effects of T6 and T6I6 ageing treatments on microstructure and properties of 6005A aluminum alloy SHENG Xiao-fei, YANG Wen-chao, XIA Cheng-dong, GONG Jing, WANG Ming-pu, LI Zhou, ZHANG Qian (School of Materials Science and Engineering, Central South University, Changsha 410083, China) Abstract: The effects of T6 and T6I6 ageing treatments on the hardness and intergranular corrosion properties of 6005A aluminum alloy were investigated using hardness test, intergranular corrosion (IGC) test, transmission electron microscopy (TEM) and high resolution transmission electron microscopy (HRTEM) analysis. The results show that the hardness of the alloy in the T6 ageing treatment approaches a maximum value of 120 HV, however, it presents a severe intergranular corrosion with an average corrosion depth of 100 μm. The precipitates with small size are discontinuous at the grain boundaries. Fine precipitates with high density can be obtained in the grains after T6I6 aging treatment, and the precipitates are still discontinuous in the grain boundaries, however, the size of the precipitates is larger than that under T6 ageing treatment. The T6I6 ageing treatment for 6005A aluminum alloy not only increases the maximum hardness (127 HV), but also enhances the intergranular corrosion resistance, and the corrosion depth is only about 30 μm. Key words: 6005A aluminum alloy; aging trea