UL94标准(中英文对照).pdf

UL94 标准 ? UL94 HB flammability standard (UL94 HB 可燃性标准 ) o Requirements for HB (HB 的要求条件 ) ? UL94 V-0, V-1, V-2 flammability standard (UL94 V-0, V-1, V-2 可燃性标准 ) o Requirements for V-0 (V-0 的要求条件 ) o Requirements for V-1 (V-1 的要求条件 ) o Requirements for V-2 (V-2 的要求条件 ) ? UL94 5VA 5VB flammability standard (UL94 5VA 5VB 可燃性标准 ) o Requirements for 5VA (5VA 的要求条件 ) o Requirements for 5VB (5VB 的要求条件 ) ? UL94 criteria summary (UL94 判定标准摘要 ) ? Glow Wire testing ? Obtaining m aterial recognition ( 取得材料认证 ) ? UL test descriptions (UL 测试描述 ) ? UL file numbers for RTP Company (RTP 公司的 UL 档案号码 ) ? Requesting a UL Yellow Card from RTP Company ( 向 RTP 公司要 UL 黄卡 ) UL 94 HB flammability standard(UL94 HB 可燃性标准 ) Specim en 试片 Length 125 mm (5 in) x Width 13 mm (0.5 in) x Thickness [typically 1.5 mm (1/16 in) or 3.0 mm (1/8 in) or 6.0 mm (1/4 in)]. 长 125mm(5)X 宽 13mm(1/2)X 厚度 [ 一般为 1.5mm(1/16) 、3.0mm (1/8) 或 6.0mm (1/4) 厚] Procedure 程序 1. Three specim ens of each thickness are tested after conditioning for 48 hours at 23 degrees C and 50% RH. 每一种厚度准备了三个试片，测试前先在 23 ℃和 50% 相对湿度下放置 48 小时。 2. Each specim en is mounted with its long axis horizontal and its short axis at a 45 degree angle. 每一试片以长轴呈水平、短轴呈 45°方式固定。 3. Each specim en is marked with two lines, 25 mm and 100 mm from one end of the specim en. 每一试片在 25mm 及 100mm 处画线做记号。 4. Each specim en is supported at one end such that its lower edge is 10 mm above a piece of wire gauze. 每一试片之一端固定，低缘下方