C990M-96中文版-使用预制弹性接缝密封胶粘结的混凝土管、检查井和预制箱形构件的接缝的标准规范（公制）.docVIP

C 990M PAGE 672 Designation: C 990M – 96编号：C 990 Metric 公制 PAGE 671 Standard Specification for Joints for Concrete Pipe, Manholes, and Precast Box SectionsUsing Preformed Flexible Joint Sealants (Metric) This specification is under the jurisdiction of ASTM C-13 on Concrete Pipe and is the direct responsibility of Subcommittee C 13.08 on Rubber Gaskets. This specification is under the jurisdiction of ASTM C-13 on Concrete Pipe and is the direct responsibility of Subcommittee C 13.08 on Rubber Gaskets.本规范由ASTM委员会C-13混凝土管委员会管辖，并且由C 13.08橡胶垫片分委会直接负责。 Current edition approved May 10, 1996. Published June 1996. Originally published as C 990M - 92. Last previous edition C 990M - 94.现行版本于1996年5月10日批准，并于1996年6月出版。最初版本编号为C 990M-92，上一版本编号 This standard is issued under the fixed designation C 990M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C 990M刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标（ε） 1. Scope 适用范围 1.1 This specification covers joints for precast concrete pipe and box, and other sections using preformed flexible joint sealants for use in storm sewers and culverts which are not intended to operate under internal pressure, or are not subject to infiltration or exfiltration limits. Joint material used in horizontal applications is intended to prevent the flow of solids through the joint.本规范涵盖预制混凝土管、箱及其他构件的接缝。预制混凝土管、箱及使用预制弹性接缝密封胶的其他构件应用在雨水道和涵洞中，雨水道和涵洞不在内压下工作或不经受渗入或渗出极限。水平应用所用接缝材料可防止液体流过接缝。 1.2 For precast concrete manhole sections, and other vertical structures, which may be operated with internal or external pressure, infiltration or exfiltration limits may be specified. Joints in vertical structures covered by this specification are intended mainly to prevent the flow of solids or f