c985m-95中文版-规定强度的无钢筋混凝土涵管、雨水管和污水管的标准规范[公制].docVIP

C 985M PAGE 663 Designation: C 985M – 95编号：C 985M–95 METRIC公制 PAGE 662 Standard Specification forNonreinforced Concrete Specified Strength Culvert, StormDrain, and Sewer Pipe [Metric] This specification is under the jurisdiction of ASTM Committee C-13 on Concrete Pipe and is the direct responsibility of Subcommittee C 13.07 on Acceptance Specifications and Precast Concrete Box Sections.本规范由ASTM委员会C-13 This specification is under the jurisdiction of ASTM Committee C-13 on Concrete Pipe and is the direct responsibility of Subcommittee C 13.07 on Acceptance Specifications and Precast Concrete Box Sections.本规范由ASTM委员会C-13混凝土管委员会管辖，并且由C 13.07验收规范和预制混凝土箱形断面分委会直接负责。 Current edition approved Sept. 10, 1995. Published October 1995. Originally published as C 985M - 83. Last previous edition C 985M - 94.现行版本于1995年9月10日批准，并于1995年10月出版。最初版本编号为C 985M-83，上一版本编号 This standard is issued under the fixed designation C 985M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (ε) indicates an editorial change since the last revision or reapproval.本标准以固定编号C 985M刊发；紧随编号后的数字表示最初采用的年份，或者是修订版的最后修订年份。圆括号中的数字表示最新重新批准的年份。上标（ε）表示自上一修订版或重新批准后的编辑性修改 1. Scope 适用范围 1.1 This specification covers nonreinforced concrete pipe designed for specified strengths and intended to be used for the conveyance of sewage, industrial wastes, and storm water and for the construction of culverts.本规范涵盖设计用于污水、工业废水、雨水排水设施和涵洞建设用规定强度的无钢筋混凝土管。 1.2 This specification is the metric counterpart of Specification C 985.本规范是规范C 985的配套公制规范。 Note 1—This specification is a manufacturing and purchase specification only and does not include requirements for bedding, backfill, or the relationship between field load conditions and the designated strength of the pipe. However, experience has shown that the successful performance of this product