AS 1733-1976 (R2018) 国外国际规范下载.pdf

AS 1733—1976 Reconfirmed 2018 Australian Standard METHODS FOR THE DETERMINATION OF GRAIN SIZE IN METALS The following scientific, industrial and governmental organizations and departments were officially represented on the committee entrusted with the preparation of this standard: Associated Chambers of Manufactures of Australia Bureau of Steel Manufacturers of Australia Commonwealth Aircraft Corporation Department of Defence Federated Chamber of Automotive Industries Institute of Steel Service Centres of Australia Metal Trades Industry Association of Australia Railways of Australia Committee Society of Automotive Engineers— Australasia Telecom Australia University of New South Wales (School of Metallurgy). This standard, prepared by Committee MT/8, Metallography, was approved on behalf of the Council of the Standards Association of Australia on 28 November 1975, and was published on 1 May 1976. Review of Australian Standards. To keep abreast of progress in industry, Australian Standards are subject to periodic review and are kept up to date by the issue of amendments or new editions as necessary. It is important therefore that Standards users ensure that they are in possession of the latest edition, and any amendments thereto. Full details of all Australian Standards and related publications will be found in the Standards Australia Catalogue of Publications; this information is supplemented each month by the magazine ‘The Australian Standard’, which subscribing members receive, and which gives details of new publications, new editions and amendments, and of withdrawn Standards. Suggestions for improvements to Aus