AS 2003-1991 (R2016) 国外国际规范下载.pdf

AS 2003—1991 Reconfirmed 2016 Australian Standard® Carbon and low alloy steel— Measurement of decarburization This Australian Standard was prepared by Committee MT/8, Metallography. It was approved on behalf of the Council of Standards Australia on 9 May 1991 and published on 12 July 1991. The following interests are represented on Committee MT/8: Australian Chamber of Manufactures Bureau of Steel Manufacturers of Australia Department of Defence Railways of Australia Committee University of Wollongong Review of Australian Standards. To keep abreast of progress in industry, Australian Standards are subject to periodic review and are kept up to date by the issue of amendments or new editions as necessary. It is important therefore that Standards users ensure that they are in possession of the latest edition, and any amendments thereto. Full details of all Australian Standards and related publications will be found in the Standards Australia Catalogue of Publications; this information is supplemented each month by the magazine ‘The Australian Standard’, which subscribing members receive, and which gives details of new publications, new editions and amendments, and of withdrawn Standards. Suggestions for improvements to Australian Standards, addressed to the head office of Standards Australia, are welcomed. Notification of any inaccuracy or ambiguity found in an Australian Standard should be made without delay in order that the matter may be investigated and appropriate action taken. AS 2003—1991 (Reconfirmed) 2016-05-27 STANDARDS AUSTRALIA