iso25532013焊接及其相关工艺图纸符号表示焊接接头.docVIP

INTERNATIONAL STANDAR D ISO 2553 Fourth edition 2013-12-15 Welding and allied processes — Symbolic representation on drawings — Welded joints Soudage et techniques connexes — Représentations symboliques sur les dessins — Joints soudés Reference number ISO 2553:2013(E) Copyright International Organization for Standardization Provided by IHS under license with ISO No reproduction or networking permitted without license from IHS Not for Resale ? ISO 2013 ISO 2553:2013(E) COPYRIGHT PROTECTED DOCUMENT ? ISO 2013 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO’s member body in the country of the requester. ISO copyright office Case postale 56 ? CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@ Web Published in Switzerland ii ? ISO 2013 – All rights reserved Copyright International Organization for Standardization Provided by IHS under license with ISO No reproduction or networking permitted without license from IHS Not for Resale ISO 2553:2013(E) Contents Page Forewordiv Introductionv 1 Scope 1 2 Normative references 1 3 Terms and definitions 1 4 Welding symbol 4 4.1 General 4 4.2 Basic welding symbol 4 4.3 Welding symbol systems 5 4.4 Elementary symbols 5 4.5 Supplementary symbols 9 4.6 Arrow line14 4.7 Reference line and weld location16 4.8 Tail 19 5 Dimensioning of welds19 5.1 General19 5.2 Cross-sectional dimensions19 5.3 Length dimensions19 5.4 Butt welds 20 5.5 Fillet welds 21 5.6 Plug welds in circular holes21 5.7 Plug welds in slots21 5.8 Spot welds22 5.9 Seam welds22 5.10 Edge welds22 5.11 Stud welds22 5.12 Overlay welds22 6 Dimensioning of joint preparations34 6.1 General34 6.2 Root gap34 6.3 Included angle 34 6