ASME SECTION II A-2 SA-479-SA-479M-2007 标准规范下载.pdf

2007 SECTION II, PART A SA-479/SA-479M SPECIFICATION FOR STAINLESS STEEL BARS AND SHAPES FOR USE IN BOILERS AND OTHER PRESSURE VESSELS SA-479/SA-479M (Identical with ASTM Specification A 479/A 479M-04 except for editorial corrections.) 07 1. Scope 2.2 Other Document: 1.1 This specification covers hot- and cold-finished bars SAE J1086 Recommended Practice for Numbering Metals of stainless steel, including rounds, squares, and hexagons, and Alloys and hot-rolled or extruded shapes such as angles, tees, and channels for use in boiler and pressure vessel construction. 3. Ordering Information NOTE 1: There are standards covering high nickel, chromium, austenitic 3.1 It is the responsibility of the purchaser to specify corrosion, and heat-resisting alloy materials. These standards are under all requirements that are necessary for material ordered the jurisdiction of ASTM Subcommittee B02.07 and may be found in under this specification. Such requirements may include, Annual Book of ASTM Standards , Vol 02.04. but are not limited to, the following: 1.2 The values stated in either inch-pound