基于单片机的电流检测电路设计.docVIP

单片机课程设计 题 目 基于电流检测电路的设计 英文题目Infrared Electric current examination electric circuit of the design 院 系 电子工程学院 专 业 自动化 姓 名 同组人员 年 级 大三 指导教师 2010年 06月 摘要 在单片机检测电流的过程中，因为电流量是模拟量，并且对于电流量不能直接进行读取，所以需要将电流量转化为电压量，再通过A/ D转换器进行读取和处理。 单片机对模拟信号的读取是通过A/D转换器来实现的，使用了ADC0809芯片，关于芯片的介绍参考后面的内容，从电流量到电压量的转换时通过电流传感器来实现的，这是检测电流的关键。 下面先介绍电流传感器的基础知识，接着介绍实现单片机电流传感器所必须的器件和软件，然后逐步分析程序的各个只要模块以及程序的全貌。 【关键词】：ADC0809，电流检测，8051单片机 Infrared electric current exanination electric circuit of the design Abstract In the course of the current SCM test, Because the electric current is the analog, And the electric current can not be read directly Therefore needs to transform the amperage as the voltage quantity, Switch carries on the read and processing again through A/the D. Microcontroller reads the analog signal through A / D converter to achieve, Use the ADC0809 chip, Reference on the chip behind the introduction content, From the amount of electric current to voltage conversion is achieved through the current sensor, This is examines the electric current the key. The following will introduce the basics of current sensor, Then the introduction realizes the monolithic integrated circuit electric current sensor to component and software , Then gradually the various analytical procedures, and procedures of the picture as long as the module. 【关键词】：ADC0809，electric current examination, Microcontroller8051 目 录 错误！未定义书签。 摘要.................................................................................................................................. I Abstract . ........................................................................................................................... 3 引 言 ............................................................................................................................. 5 第一章 总体设计............................................................................................................ 6 第二章 控制系统的硬件设计 ...............................................................