ASME SECTION II C SFA-5.01-2008 国外国际规范.pdf

2008a SECTION II, PART C SFA-5.01 FILLER METAL PROCUREMENT GUIDELINES SFA-5.01 (Identical with AWS Specification A5.01:1993 (R1999). In case of dispute, the original AWS text applies.) A08 1. Scope 4. Definitions and Identification of Materials This document, together with an AWS filler metal speci- 4.1 Introduction. In production, the components of the fication, is intended to describe a uniform method for pro- filler metal are divided into discrete, predetermined quanti- viding those specific details needed for filler metal ties so that satisfactory tests with a sample from that quan- procurement which consist of the following: tity will establish that the entire quantity meets specification requirements. These quantities, known by (1) The filler metal classification (selected from the per- such terms as heats, lots, blends, batches, and mixes, vary tinent AWS filler metal specification) in size according to the manufacturer. For identification (2) The lot classification (selected from Section 5 of purposes, however, each manufacturer assigns a unique this document) designation to each quantity. This designation usually con- (3) The level of testing schedule (selected from Table