C121技术交底C121+土方开挖施工技术交底.doc

施工技术质量交底记录 Construction Technology Quality Clarification Record 项目名称project 扬巴二期改造项目 IPS II PROJECT 施工单位construction unit 中石化五公司 FICC 工程名称work IB/PIB C121 交底日期clarification date 2010年04月29日 2010-04-29 交底地点location 现场办公室 field office 交底部位及工序process 基础foundation---土方开挖excavation 执行规范和规程execution procedures 《建筑地基基础工程施工质量验收规范》GB50202-2002 Specification for Foundation Construction Quality Inspection And AcceptanceGB50202-2002 交底内容 clarification content： 一、施工准备 construction preparation 1、 轴线定位标桩已设置并保护好。Axis positioning stake is set and protected 各种土方施工机具和现场临时通道正常,临时设施和安全措施准备就绪。All excavation 2、equipment tools and temporary passage perform well,temporary facilities and safety measures prepared 基坑周边灰线已放且验收合格。 、 3inspectionpasses and set around foundation Gray Line has been 二、操作要点 key points for operation 1、 基坑土方开挖采用履带式单斗挖掘机进行开挖，挖出的土方用自卸汽车运输到指定的弃土地点。Use crawler shovel for foundation pit excavation,excavated earth is transported to designated site by dump truck 2、 机械挖土时设专人指挥挖掘机施工作业，机械挖土到设计底标高上200mm的位置后用人工清理至设计的底标高。注意各基础底不同标高的控制。Assign specialist to direct mechanical excavation.After excavator arrives 200mm above design elevation,resume excavation through manual work down to designed foundation elevation.Pay attention to elevations of different foundation bases. 3、 在每个基坑底边设置排水沟和一个集水井。排水沟断面尺寸为0.3×0.3米，沿基坑周边设置，排水沟底坡度5%流向集水井，集水坑尺寸为0.8×0.8×1.0米（深）。集水坑内设污泥泵一只，当基坑内有水时，派专人做好坑内的排水降水工作。Set a drainage ditch and collecting well at the hemline of each foundation pit.Section dimension of drainage ditch is 0.3×0.3m, with 5% bottom slope facing collecting well.Collecting dimension is 0.8×0.8×1.0m(d).Fix a slime pump in collecting well and send assigned people for dewatering in case of water deposit. 三、质量标准 quality standard 1、 开挖尺寸、坑底标高符合设计和规范要求。Excavation dimension and foundation bottom elevation conforms with design requirements and specification smooth,dust be should bottom Pit 边坡符合施工方案要求。虚土清理干净，坑底要平整， 、2． cleared out,side slope conforms