9F燃机启动调试步骤.pdf

实用标准 Day/Date Test 试验 Purpose of Test 试验目的 Test activities 试验活动 Remarks 备注 天/ 日期 Day 1 Rotor run- 1. Listen for rubs or unusual noises 1. Roll up to 50 rpm trip by DCS emer- ? Use auto start-up sequences to prepare the 第 1 天 in: 听是否有摩擦和异常噪音 gency push button and 200 rpm and trip unit for a “-to-ReadyStart 采用自动走动” 11/08/2006 转子试 2. Functional test of emergency trip by GT MK 6 control emergency stop 通 顺序将机组准备好“准备起动” 转： button 紧急跳闸按钮的功能试 过 DCS 紧急按钮逐渐增加到 ? Rub checks are performed检查摩擦 Crank test 验 50rpm，通过 GT MK6 控制紧急停机 ? ADRE vibration monitor to be connected 摇转试验 3. Purge speed cranking for rotor 跳闸 连接 ADRE 振动监视器 vibration check 以吹扫速度摇 2. Restart, accelerate to go to Purge speed After Shut-down 停机后 转，检查转子振动情况 for 5min and select normal stop 重起， ? Reinstate the piping spool of D5 and PM4 4. Monitor LCI starting tempera- 加速到吹扫速度 5 分钟，选择正常停 pipe work after shutdown 停机后重新恢 tures and operation监视器 LCI 止 复 D5 和 PM5 管子的导管 起动温度和运行 3. Restart, hold at purge speed and air 5. Air blowing the purge piping of blowing the piping of D5 and PM4, trip D5 and PM4 gas fuel during by DCS customer trip (L4CT) after 30 crank 摇转期间给 D5 和 PM4 吹 Min crank test 重起，保持在吹扫速 扫管鼓风 度，给 D5 和 PM4 管道鼓风，在 30 6. Check operation of lift oil and 分钟摇转