美国船级社标准ABS Steel Vessels Under 90 Meters (295 Feet) in Length RCN 4.pdfVIP

RULES FOR BUILDING AND CLASSING STEEL VESSELS UNDER 90 METERS (295 FEET) IN LENGTH 2006 NOTICE NO. 4 – July 2007 The following Rule Changes were approved by the ABS Rules Committee on 7 June 2007 and become EFFECTIVE AS OF 1 JULY 2007*. (See /rules/downloads.html for the consolidated version of the Rules for Building and Classing Steel Vessels Under 90 meters (295 feet) in Length 2006, with all Notices and Corrigenda incorporated.) Notes * Except the change to 3-6-1/1.1.1, which is effective as of 1 July 2006 (based on the “keel laying” date or similar stage of construction) in line with the 2003 Amendments to SOLAS 1974, Chapter V, Reg. 2.4 {Resolution MSC 142(77)}. - The date in the parentheses means the date that the Rule becomes effective for new construction based on the contract date for construction, unless otherwise noted. (See 1-1-4/3.3.) - The date in the parentheses with underline means that the Rule becomes effective based on the “keel laying” date or similar stage of construction. PART 3 HULL CONSTRUCTION AND EQUIPMENT CHAPTER 3 SUBDIVISION AND STABILITY SECTION 1 GENERAL REQUIREMENTS (Delete last sentence and Note in Subsection 3-3-1/9, to read as follows.) 9 Onboard Computers for Stability Calculations (1 July 2007) The use of onboard computers for stability calculations is not a requirement of class. However, if stability software is installed onboard vessels contracted on or after 1 July 2005, it should cover all stability requirements applicable to the vessel and is to be approved by the Bureau for compliance with the requirements of Appendix 3-3-A2, “Onboard Computers for Stability Calculations”. ABS RULES FOR BUILDING AND CLASSING STEEL VESSELS UNDER 90 METERS (295 FEET) IN LENGTH . 2006 1 Notice No