美国船级社标准ABS Steel Vessels Under 90 Meters (295 Feet) in Length RCN 2.pdfVIP

RULES FOR BUILDING AND CLASSING STEEL VESSELS UNDER 90 METERS (295 FEET) IN LENGTH 2006 NOTICE NO. 2 – November 2006 The following Rule Changes were approved by the ABS Rules Committee on 6 June 2006 and become EFFECTIVE AS OF 1 JANUARY 2007. (See /rules/downloads.html for the consolidated version of the Rules for Building and Classing Steel Vessels Under 90 meters (295 feet) in Length 2006, updated in November 2006, with all Notices and Corrigenda incorporated.) Notes - The date in the parentheses means the date that the Rule becomes effective for new construction based on the contract date for construction, unless otherwise noted. (See 1-1-4/3.3.) - The date in the parentheses with underline means that the Rule becomes effective based on the “keel laying” date or similar stage of construction. PART 3 HULL CONSTRUCTION AND EQUIPMENT CHAPTER 2 HULL STRUCTURES AND ARRANGEMENTS SECTION 6 BEAMS, DECK GIRDERS, DECK TRANSVERSES AND PILLARS 1 Beams (Revise and expand Paragraph 3-2-6/1.6, as follows.) 1.6 Deck Fittings (2007) 1.6.1 General The strength of supporting hull structures used for mooring operations and/or normal towing operations at bow, sides and stern are to comply with the requirements of this section. Deck fittings for mooring and/or towing are to be located on longitudinals, beams and/or girders, which are part of the deck construction so as to facilitate efficient distribution of the mooring and/or towing load. The same attention is to be paid to recessed bitts, if fitted, of their structural arrangements and strength of supporting structures. 1.6.2 Design Loads Unless greater safe working load (SWL)