面试问题库Top300+项CCIE面试名问题(Part3).docVIP

EIGRP ??Does EIGRP require an ip default-network command to propagate a default route? EIGRP是否需要IP 默认网络命令来传播默认路径？ ? ??Should I always use the EIGRP log-neighbor-changes command when I configure EIGRP? 配置EIGRP时是否应始终使用EIGRP log-neighbor-changes命令？ ? ??Does EIGRP support secondary addresses? EIGRP是否支持辅助地址？ ? ??What debugging capabilities does EIGRP have? EIGRP有哪些调试功能？ ? ??What does the word SERNO mean on the end of an EIGRP topology entry when you issue the show IP EIGRP topology command? 当您发出显示 IP EIGRP拓扑命令时，SERNO这个词在EIGRP拓扑表末尾是什么意思？ ? ??What percent of bandwidth and processor resources does EIGRP use? EIGRP使用的带宽和处理器资源的百分比是多少？ ? ??Does EIGRP support aggregation and variable length subnet masks? EIGRP是否支持聚合和可变长度的子网掩码？ ? ??Can I ?configure more than one EIGRP autonomous system on the same router? 可以在同一路由器上配置多个EIGRP自治系统吗？ ? ??What does the neighbor statement in the EIGRP configuration section do? EIGRP配置部分的邻居语句是做什么的？ ? ??When I configure EIGRP, how can I configure a network statement with a mask? 配置EIGRP时，如何配置具有掩码的网络语句？ ? ??I have two routes: 172.16.1.0/24 and 172.16.1.0/28. How can I deny 172.16.1.0/28 while I allow 172.16.1.0/24 in EIGRP? 我有两条路线：172.16.1.0/24和172.16.1.0/28。在拒絕172.16.1.0/28情況下，如果在EIGRP允许172.16.1.0/24？ ? ??How do you verify if the EIGRP Non Stop Forwarding (NSF) feature is enabled? 如何验证EIGRP的非停止转发（NSF）功能是否启用？ ? ??How can I use only one path when a router has two equal cost paths? 如果路由器具有两条相同的成本路径，如何只使用一条路径？ ? ??What is the difference in metric calculation between EIGRP and IGRP? EIGRP与IGRP之间的度量计算有何不同？ ? ??What is the EIGRP Stub Routing feature? 什么是EIGRP 存根路由功能？ ? ??How can I send a default route to the Stub router from the hub? 如何从集线器发送默认路径到存根路由？ ? ??What are different route types in EIGRP? EIGRP中有哪些不同的路由类型？ ? ??How do you redistribute an IPv6 default route in EIGRP? 如何在EIGRP中重新分配IPv6默认路由？ ? ??How does EIGRP behave over a GRE tunnel compared to a directly connected network? 与直接连接的网络相比，EIGRP在GRE隧道上的行为如何？ ? ??How can I tag external routes in EIGRP? 如何在EIGR