轮机员英语面试(轮机长、大管轮、二管轮、三管轮适用).docxVIP

轮机员英语面试（轮机长、大管轮、二管轮、三管轮适用） 1、Can you measure oil level? Which method is right, to measure ullage height or to measure oil depth? Both will do. In practice, to measure ullage height is more specific than to measure oil depth. To measure ullage height, we should know the standard height of oil tank. In common practice, we usually measure the oil depth. 2、Could you tell the working parts of a gas welding gun? Yes, sir. The working parts include nozzle, oxygen valve, acetylene valve, oxygen supply, acetylene supply. In addition, filler rod is used to fill in welded joint when it melts. 注：焊枪是轮机部常用的维修工具，工作时这些部件名称经常涉及到。 3、How to pump out bilge water in the engine room? Pump bilge water into sludge tank. Then pump bilge water into oily water separator. Enquire master or deck officers on duty to pump out at appropriate water. The proportion should not beyond 15 PPM.机舱排污水程序可表述为把污水排到污水集中柜内，再通过油水分离器在允 许排放区域按含油量小于 15 PPM 排放。 4、When will an Engineer Officer in charge of watch call Chief Engineer? When engine damage or malfunction occurs which may be such as to endanger the safe operation of the ship; when any malfunction occurs which it is believed, may cause damage or break down of propulsion machinery, auxiliary machinery or monitoring and governing systems; and in any emergency or if in any doubt as to what decision or measure to be taken. 5、What must be handed over to relieving Engineer Officer at transition of change command? If possible, the condition and mode of operation of automatic boiler controls such as flame safeguard control systems, limit control system, combustion control system, fuel-supply control systems, and other equipment related to the operation of steam boilers; and potentially adverse conditions due to bad weather, ice, contaminated or shallow water; any special modes of operation dictated by equipment failure or adverse ship conditions; reports of engine-room ratings relating to their assigned duties; the availability of fire-fighting appliances; the sta