品质术语汇总.docVIP

一、品质人员名称类：QC? ?quality control??品质管理人员 FQC? ?final quality control??终点质量管理人员 IPQC? ?in process quality control??制程中的质量管理人员 OQC??output quality control??最终出货质量管理人员 IQC??incoming quality control??进料质量管理人员 TQC??total quality control??全面质量管理 POC??passage quality control??段检人员 QA??quality assurance??质量保证人员 OQA??output quality assurance??出货质量保证人员 QE??quality engineering??品质工程人员二、品质保证类：FAI? ?first article inspection??新品首件检查 FAA??first article assurance??首件确认TVR??tool verification report??模具确认报告 3B??3B??模具正式投产前确认 CP??capability index??能力指数 CPK??capability index of process??模具制程能力参数 SSQA??standardized supplier quality??合格供货商品质评估 OOBA??out of box audit??开箱检查 QFD??quality function deployment??品质机能展开 FMEA??failure model effectiveness analysis??失效模式分析 8 disciplines??8项回复内容 FA??final audit??最后一次稽核 CAR??corrective action request??改正行动要求 corrective action report??改正行动报告 三、FQC运作类 AQL??Acceptable Quality Level??运作类允收品质水准 S/S??Sample size??抽样检验样本大小 ACC??Accept??允收 REE??Reject??拒收 CR??Critical??极严重的 MAJ??Major??主要的 MIN??Minor??轻微的 AOQ??Average Output Quality??平均出厂品质 AOQL??Average Output Quality Level??平均出厂品质 Q/R/S??Quality/Reliability/Service??品质/可靠度服务 MIL-STD??Military-Standard??军用标准 S I-S IV??Special I-Special IV??特殊抽样水准等级 P/N??Part Number??料号 L/N? ?Lot Number??特采 AOD??Accept On Deviation??特采UAI??Use As It??首件检查报告 FPIR??First Piece Inspection Report??百万分之一 PPM??Percent Per Million??批号四、制程统计品管专类：SPC??Statistical Process Control??统计制程管制 SQC??Statistical Quality Control??统计质量管理 R??Range??全距 AR??Averary Range??全距平均值 UCL??Upper Central Limit??管制上限 LCL??Lower Central Limit??管制下限 MAX??Maximum??最大值 MIN??Minimum??最小值 GRR??Gauge ReproducibilityRepeatability??量具之再制性及重测性判断量可靠与否 DIM??Dimension??尺寸 DIA??Diameter??直径 FREQ??Frequency??频率 N??Number??样品数五、其它品质术语类：QCC??Quality Control Circle??品质圈 QIT??Quality Improvement Team??品质改善小组 PDCA??Plan Do Check Action??计划 执行 检查 总结 ZD??Zero Defect??零缺点 QI??Quality Improvement??品质改善 QP??Quality Pol