天线汇报总结.pptxVIP

介电常数??r = 2. 5 纸质介质基板厚度为1mm;图4εr对天线电阻R天线的影响;图6 RFID标签(1)结构侧面图;从图7和图8中可以看出, 采用新标签时, 当h= 2 mm 时, 新标签天线的电阻和电抗曲线较平缓, 对物品介电常数不敏感。波动范围在50~ 100之间。但RFID 标签IC的电阻较小( 20左右), 而标签天线电阻的波动范围( 50~ 100)仍然太大, 与RF ID标签芯片匹配存 在困难。;为了进一步改善RFID 标签天线对物品介电 常数的适应性, 本文提出了把空气层和金属层面积扩大一倍; 由表1和表2可以看出, 在不同介电常数的物 品影响下, RFID标签天线(#)和标签天线(%的阻抗测量值均保持不变。其中, RFID 标签(%)天线电阻和电抗始终保持在20 ? 和800 ? 左右, 基本接近常用的RFID 标签芯片阻抗目标, 具有很高的应用价值。;Chipless RFID Tag Using Hybrid Coding Technique;Table I presents the key parameters for each ECP,such as the 3 dB bandwidth and the RCS (Radar Cross Section)magnitude. Simulation results are obtained by using CST Microwave.Studio with plane wave excitation;;Fig. 3. Basic resonating element based on a metallic strip like-“C” structure;Fig. 4. Simulated and modeled RCS amplitude of a “C” ECP for different gap values. ; 牛牛文库文档分享; 牛牛文库文档分享;Fig. 10.(a)Absence/presencecoding technique introduced by Jalaly [8]. (b)Frequency shift coding technique [13].;Fig. 12. Coding principle using both phase and frequency shift encoding.;Fig. 13. 2D Constellation diagram for hybrid technique combining phase deviation to frequency shift encoding.;Fig. 14. Measurement set-up using a VNA HP8720D in bi-static configuration.Antennas and tag are put inside an anechoic chamber.;Fig. 15. [RCS]magnitude measurements for tag 1, 4 and 5.;Fig. 17. [RCS] magnitude measurements for tag 1, 6 and 7.;TABLE III HALF DEVIATION PHASE BANDWIDTH IN MHz AS A FUNCTION OF TAG CONFIGURATION;TABLE IV FREQUENCY OF THE RESONANCE PEAK IN MHz AS A FUNCTION OF TAG CONFIGURATION; 牛牛文库文档分享; 牛牛文库文档分享;3. Novel Chipless RFID Tagfor Conveyor Belt Tracking using Multi-Resonan Dipole Antenna;tag cost and as such, there are limitations that govern its use. Many low cost RFID applications will place the tagged items on a conveyer belt type system where the reader antenna is fixed and the transponder moves past the reader in a predictable way, or where the tagged item is stationary and the reader is in some sort of handheld device that can