dynamartm泰乐玛聚合物加工助剂在塑料软包装业的应用.pptVIP

;泰乐玛聚合物加工助剂;FX 9613;泰乐玛聚合物加工助剂—机理;泰乐玛聚合物加工助剂--应用;泰乐玛聚合物加工助剂--功效;泰乐玛聚合物加工助剂 与 塑料软包装 ？！? !;塑料软包装 – 常用原料;塑料软包装 – 常见工艺;塑料软包装 – 常见工艺;塑料软包装 – 常见工艺;塑料软包装 – 常见工艺;塑料软包装 – 常见问题;泰乐玛聚合物加工助剂 ;1，LLDPE/LDPE 薄膜实验； 2，HMW-HDPE 薄膜实验； 3，HDPE 薄膜实验；;实验 1 在恒定产量下泰乐玛对模口压力和能量消耗的作用.;Material:;Experiment 1: Resin with PPA Die Pressure versus %LLDPE;Experiment 1: Resin without PPA Die Pressure versus %LLDPE;Experiment 1: Comparing with and without PPA Die Pressure versus %LLDPE;Experiment 1: Comparing with and without PPA Energy Consumption versus % LLDPE;实验 2 Effect on melt temperature at constant die pressure and output;Experiment 2: Comparing with and without PPA Melt Temperature versus %LLDPE;EXPERIMENT 3 Effect on output at constant die pressure and melt temperature;Experiment 3:Comparing with and without PPA output versus %LLDPE;TENSILE STRENGTH versus LDPE/LLDPE COMPOSITION;% ELONGATION versus LDPE/LLDPE COMPOSITION;TEAR STRENGTH versus LDPE/LLDPE COMPOSITION;% Transmission;CONCLUSIONS Using PPA : *Allowing higher LLDPE ratios to be used in the LDPE/LLDPE blends *Allowing higher outputs at equivalent die pressures *Allowing low melt temperatures at equivalent die pressures * Increase the physical properties of the film by increase the concentration of LLDPE in an LDPE/LLDPE resin blend to decrease resin costs ;Equipment Extruder: Dyneon Kiefel blown film line grooved barrel, 40mm, 24/1 L/D Die: 40mm diameter, 0.6mm die gap Materials Base Resin: HMW-HDPE, 10 HLMI, 0.948 dens. PPAs: 3% FX-9613 in 2 MI LLDPE 3% FX-5920A in 2 MI LLDPE 3% FX-5911X in 2 MI LLPDE ;Run Conditions Melt temperature: 205oC Output: 15 kg/hr Shear rate: 640 s-1 Procedure ? Run base resin for 30-60 minutes ? Run base resin +700ppm PPA for 2 hours ;Gate Pressure Reduction;Blown film;Equipment Extruder: Dyneon Collin blown film line Smooth barrel, 45mm, 25L/D Die: 50mm diameter, 0.6mm die gap Materials Base Resin: HDPE, 18 HLMI, 0.948 dens.