四种绑定在zstack中的应用.docxVIP

KuangJunBin :本 文是作者根据 TI Z-Stack 开发文档，ZigBee Specification-2007 ,《Zigbee Wireless Networking 》等英文资料整合和翻译而成，采用中英双语对照方便读者理解，文中翻译不当之 处，望广大同行不吝赐教。推广 ZigBee技术，提高国 内电子行业的国际影响力，是我们无线通讯工程师 的愿景。本文欢迎转载，请保留作者信息和岀处，作为支持我继续努力前行的动力，谢谢！ E-mail: kuangjunbin@ In the Zigbee 2006 release,the binding mechanism is implemented in all devices and is called source binding. Binding allows an application to send a packet without knowing the destination address,the APSlayer determines the destination address from its binding table,and then forwards the message on to the destination application(or multiple applications)or group. ZigBee2006 版本中规定，在全部节点中实现绑定机制，并将其称为源绑定。绑定机制允许一个应用服务 在不知道目标地址的情况下向对方(的应用服务)发送数据包。发送时使用的目标地址将由应用支持子层 从绑定表中自动获得，从而能使消息顺利被目标节点的一个或多个应用服务，乃至分组接收。 Binding Table 1.Defined in RAM,but can be saved in Flash if the NV_RESTORE compiler option is used 2.Stored on source node(REFLECTOR compiler option required) Entries map messages to their intended destination Each entry in the binding table contains the following: typedef struct { uint16 srcldx;//Source index uint8 srcEP;//Source endpoint uint8 dstGroupMode;//Specifies normal or group addressing uint16 dstIdx;//Destination index or group address uint8 dstEP;//Destination endpoint uint8 numClusterIds;//Number of cluster IDs in the clusterIdList below uint16 clusterldList[MAX_BINDING_CLUSTER_IDS]; }BindingEntry_t; 绑定表 绑定表存放的位置是内存中预先定义的块，如果编译选项 NV_RESTOR被激活，也能保存在Flash里。 绑定表放置在源节点(需要激活编译选项 REFLECTOR。 绑定表的条目把需要发送的消息映射到它们的目标地址上。 绑定表中每个条目包括以下内容： 绑定表条目结构体的定义 typedef struct { uint16 srcIdx; // 源地址索引 uint8 srcEP; // 源端点 uint8 dstGroupMode; // 指定寻址模式 uint16 dstIdx; // 目标地址索引或者分组号 uint8 dstEP; // 目标端点 uint8 numClusterIds; // 在簇标识符表中簇标识符的个数 uint16 clusterIdList[MAX_BINDING_CLUSTER_IDS]; // 簇标识符表 }BindingEntry_t; Simple Description --- How to bind devices A binding is a logical link between two devices at the application layer. Multiple bindings can be created on a device, one for each type of data packet. In addition, a binding may have mor