锂电池充放电均衡系统研究(1).docVIP

作者：大月亮 MACROBUTTON MTEditEquationSection2 SEQ MTEqn \r \h SEQ MTSec \r 1 \h SEQ MTChap \r 2 \h 锂电池充放电均衡系统研究 姓名：张啸 学院：物电学院 摘 要：在本文中通过对锂离子电子进行简化，然后通过电化学方程建立数学模块然后对电路模型进行等效搭建，通过查阅不同的资料和文献对各种型号进行有点和缺点不同程度的分析，本文综合考虑实际应用问题决定采用RC二阶电路用来对锂电子模型进行搭建起到等效电路的作用。然后通过对单节锂电池做对比实验，通过一些列的实验表明，当采用开路电压快速测取法时，然后再使用开路快速测取法，最终能够确定SOC曲线。然后使用开路电压对电池两端电压进行比较，从而能够进一步验证本文的SOC曲线值得正确性。在识别结果组合，它描述了使用SOC值的锂离子电池模型参数的变化趋势。辅助RC已经使用识别结果选择。 通过仿真验证了等效电路模型，模拟结果证明了二阶RC电路作为锂离子电池等效电路的正确性。 关键词：二阶RC等效电路；参数辨识；锂离子电池 Research on charge - discharge equalization system of lithium battery Zhang Xiao, School of physics and electronic information Abstract：In this article, through the simplification of lithium ion, and then by electrochemical equation mathematical module and the equivalent circuit model, through the different data and literatures on various models for a bit and disadvantages of different level analysis, in this paper, considering the actual application problem decided to adopt the RC second-order circuit used to build lithium-ion models have the effect of equivalent circuit. Then, through a series of experiments on a single lithium battery, it is shown that the SOC curve can be determined finally when the open circuit voltage rapid sampling method is adopted, followed by the open circuit rapid sampling method. Then the open circuit voltage is used to compare the voltages at both ends of the battery so as to further verify the correctness of SOC curve in this paper. In the combination of identification results, it describes the variation trend of parameters of the lithium ion battery model using SOC values. Auxiliary RC has used identification result selection. The equivalent circuit model is verified by simulation, and the simulation results show that the second-order RC circuit is correct as the equivalent circuit of lithium ion battery. Key words: two order RC equivalent circuit; parameter identification; lithium ion battery 目 录 TOC \o 1-3 \h \z \u 1绪论 1 1.1 选题背景与意义 1 1.2 锂电子电池基本