空冷器风机变频器的dcs状态显示控制系统改造.docVIP

空冷器风机变频器的DCS状态显示控制系统改造 导语：?空冷器风机在DCS系统中的状态只有正常运行显示，没有停机或者故障显示，变频器保护停机后的再启动的时间间隔将会引起系统操作参数波动，影响产品质量和正常生产 摘要：空冷器风机在DCS系统中的状态只有正常运行显示，没有停机或者故障显示，变频器保护停机后的再启动的时间间隔将会引起系统操作参数波动，影响产品质量和正常生产。针对这种情况将变频参数优化与控制线路改进，使空冷器风机变频器保护停运时，DCS系统能显示空冷器风机停运并发出报警信号，重新启动时间由原来3 min减少到5 S以内，大大缩短了空冷器风机启动时间，解决了空冷器风机停运对装置造成的影响，确保了生产的连续平稳运行。关键词：风机；变频器；控制系统；改造[b][align=center]Modifications to Frequency Transformer Control Systemof the Fan of Air Cooler in DCS SystemZHANG Xue—feng，BIAN Lian—fang，LIU Feng，CHEN Feng（Natural Gas Processing Plant of Zhongyuan OilGas High Technology Stock Co．，Ltd．，Henan Puyang 457162，China）[/align][/b]Abstract：In DCS system，although the state of air eooler on normal operation is well informed，no message is available when the fan of air cooler is in shutdown and/or breakdown and the longer restart time is one of mainreasens for the unsteadiness of operational parameters and product quality．To solve this problem，we had opti—mized frequency transformer param eters and improved the control circuits，added the alarm message to DCS sys—tem once the air cooler fan is in breakdown ．At the same time，we improved the restart time from 3 minutes to 5 seconds．Based on these eflbrts，the negative influence of shutdown and/or breakdown on the production system is avoided thorouhgly．Key words：fan ；frequency transform er；control system；modification1 改造前系统状态（1）正常启动过程：按下启动按钮SB2后由L11→FU→KA→SB1→SB2→→KM→KH→N构成回路，KM和KA1得电吸合，松开SB2后由于KM的触点的自锁作用，KM和KA1保持吸合。变频器TD2000得电，FWD为变频器运行控制输人端，KA1闭合使变频器进入运行状态，空冷器风机得电运转。此时KM的常开触点闭合，DCS系统显示空冷器风机运行。[b][align=center]详细内容请点击：空冷器风机变频器的DCS状态显示控制系统改造[/align][/b]