制浆造纸企业QDW T 7300复卷机自动化培训讲义完整版.ppt

* Open WINDER S7-program and from there FC15 Network 7. Make sure that there is no cores on drums and after that close core lock. Set relief bit M15.3 On. Core guiders relief control - calibration HYDRAULICS * Check core guider floating from both sides (OS/DS) by lifting it from pipe your own hands. Relief pressure is well adjusted when core guider is possible lift up by using app. 20kg force. If relief of the core guider is too small or too big increase or reduce constant value. Core guiders relief control - calibration HYDRAULICS * COMMUNICATION:Winder ? Drives Winder PLC gives all setpoint values to Drives system Tension controller and Acc/Dec compensation are at Drives system Lengh Calculation and also Autostop calculation are at Drives system Setpoint via Winder and Drives Communication Link FC142 (Communication calls) FC143 (Setpoints to Drives) FC144 (Drives Actual values) DB142 (Communication data block) See Link data: P1335 Winder - Drives signal description v1.5.doc * WINDER DIAGNOSTIC Crawl/Start permissions Small square on the left side of text is green when permission is on * WINDER DIAGNOSTIC Set change sequence Interlockings Small square on the left side of text is green when permission is on * WINDER DIAGNOSTIC Profibus diagnostic Address of the Profibus-DP slave For example: 31 is address of the TB31 ET200S Substation 17 is address of the OS Core lock position sensor Colour information of the slaves * WINDER DIAGNOSTIC Drives maintenance-mode Selection Push-button for Maintenance mode NOTE! Login name and correct password required! Push-buttons for start/stop drive motor separately Speed reference field when maintenance mode selected. * 西门子Step7程序: Main program structure: OB1 Normal cyclical program calls OB35 100ms time interrupted program calls FB’s are used if function needs static, internal memory FC’s are used if function needs only temporary memory For example: 踢辊器 circuit number =12 FC12, FB12 and DB12 reserved for 踢辊器 controls * M