课件英文版大连理工21st lecture.pptVIP

Press ESC to quit Mechanical drawing (electronic lecture) Section 4 Composite-cutting view Section 5 Cross Sections (断面图) Lab of graphics study and communication, DUT Song HX 21st lecture Representations for work-pieces (4) Review Evaluation only. Created with Aspose.Slides for .NET 4.0 Client Profile 21.2. Copyright 2004-2021Aspose Pty Ltd. §4 Composite-cutting sectional view Definition: when a work piece is complicated enough and any single representation could not describe it clearly, parallel cutting planes and intersecting cutting planes are usually combined together to make a composite cutting form a composite –cutting sectional view. E.g.1 E.g.2 Evaluation only. Created with Aspose.Slides for .NET 4.0 Client Profile 21.2. Copyright 2004-2021Aspose Pty Ltd. model Evaluation only. Created with Aspose.Slides for .NET 4.0 Client Profile 21.2. Copyright 2004-2021Aspose Pty Ltd. model E.g. 1 Evaluation only. Created with Aspose.Slides for .NET 4.0 Client Profile 21.2. Copyright 2004-2021Aspose Pty Ltd. model E.g. 2 Evaluation only. Created with Aspose.Slides for .NET 4.0 Client Profile 21.2. Copyright 2004-2021Aspose Pty Ltd. §5 Cross Sections（断面图） 1. Definition: Using an imaginary cutting plane to cut an object, section is created , as shown in the following figure. Only draw the section touched by the cutting plane, according to the direction of sight, unfold the section at 90°, the cross section drawing is obtained. 2. Classification: Removed sections Revolved sections E.g.3 E.g.4 Comparision Evaluation only. Created with Aspose.Slides for .NET 4.0 Client Profile 21.2. Copyright 2004-2021Aspose Pty Ltd. ☆ When cutting planes pass through the holes or notches formed by revolving surfaces, represent them like sectional views . 1) Removed sections（移出断面） A removed section should be placed out of its father view (remain the projection relationship with its father view), arranged at any free space (generally at the extension line of the cutting plane or ot